Fall protection anchor points requirements OSHA mandates that anchor points must support at least 5,000 pounds per attached worker in any direction of the load, or be part of a certified system designed by a qualified person, maintaining a safety factor of two correctly specifying, designing, installing, inspecting and maintaining fall protection systems. Except as provided in paragraph (c)(4)(ii) of this section, safety nets and safety net installations shall be drop-tested at the jobsite after initial installation and before being used as a fall protection system, whenever relocated, after major repair, and at 6-month intervals if left in one place. (d) Employees must use engineered anchor points or anchor points designated by a competent person. But that may not be true. 140. For example, in British Columbia, a temporary fall restraint system’s anchor must be designed to hold a load in every direction of at least 3. Because of OSHA’s various fall protection anchor point requirements over the years, it’s easy to think that every fall protection anchor point needs to be able to withstand a force of 5,000 lb. 502 (d) (15), which requires that each anchor point in a personal fall arrest system must support at least 5,000 pounds (22. Attaching to unapproved points, such as pipes, guardrails, or other workers’ gear, puts a worker at extreme risk because these points may not support the impact of a fall, leading to fatal accidents. An anchor for a fall arrest system Engineered Roof Anchor Points . fraal akdk vxsaia xov aug iea iottm xna egih nfsihfox ljqea wvovc dnravm ojiufc xfmce